Alinco DJ-296T 220 MHz Radio

Affordable 220 MHz operation is possible with the Alinco DJ-296T. This HT is only 2.2 x 4.9 x 1.6 inches (56x124x40 mm).

The DJ-296T features, alpha display, 4.5 watt output, 160 memories plus call channel, 9 autodialer memories, battery saver function, cable cloning function, direct frequency entry, auto power off with Morse alert, mosquito repel sound function, direct keypad frequency entry, backlit display and keypad, monitor and low power transmit keys and time-out timer. The DJ-296T also has extended receive from 216 to 250 MHz (FM). The DJ-296T also features a backlit keypad.

This radio comes with the EDC-93 wall charger, EBP50N NiMH battery pack, BNC flexible rubber duck antenna, belt clip and hand strap.

  • 4.5 Watt Output
  • 160 Memories
  • Extended Receive
  • Battery Saver
  • Direct Frequency Entry
  • S-Meter
  • 13.8 VDC Direct Input
  • Scanning
  • CTCSS Encode/Decode
  • DCS and 4 Tone Bursts
  • 9 Autodial Memories
  • Mosquito Repeller
  • Backlit Keypad


Frequency Coverage: TX: 222.000 to 224.995MHz
RX: 216.000 to 249.995MHz
Mode: F3E
Channel Step: 5, 10, 12.5, 15, 20, 25 & 30KHz
Antenna Port: BNC 50 ohms
Stability: +/- 5 ppm
Microphone impedance: 2k ohms
Power supply requirement: 7.0 to 16.0Vdc negative ground
Current drain(typical): 1.2A at 5W
200mA at RX 280mW AF out
50mA at Stand-by
20mA at Battery Save On
Operating temperature: -10 to +60 degrees C. (14 to 140 F)
Dimension: With EBP50N battery
2.2" x 4.88" x 1.46" inches
(56 x 124 x 37mm)
Weight: 11.0Oz (310g) with EBP50N
TX power output: 4.5W with EBP50N Ni-MH battery
5.0W at 13.8V rated DC input
0.8W Low power position
Modulation: Variable reactance FM
Sprious Emissions: Less than ?60dB
Circuit: Double superheterodyne
Sensitivity: Less than -12dbu (0.25uV)
Selectivity: More than -6dB/12kHz or more
-60dB/26kHz or less
AF output: 280mW typical 8 ohm load
Accessories: Perfectly compatible to
DJ195/196/496/596 series



EMS-47 mic , EDH-30 AA Battery pack

Revised: 02/25/08
All Rights Reserved